Hendy
05-13-2007, 09:22 PM
It never fails, I was mounting my Hi-Lift (knock-off, Torin) jack this afternoon once "Old Yellow" finally came out. Drilled the holes too close to the bumper ends so I had to take them off, since I have no Torx bits, I just drilled them out instead. This being said, I get the jack mounted and the drill dies on me as I am trying to drill out the right side bolts so now I have an end cap on the right and none on the left :bang: :bang: :bang:
The jack is mounted but the project has no closure as of yet until the stupid drill recharges :mad: :mad: And I broke one of the mounting bolts as I was putting it on which makes me question how good those bolts will hold??? That would suck to be driving down 64 and see the jack bouncing through the windshield of the car behind me...
The jack is mounted but the project has no closure as of yet until the stupid drill recharges :mad: :mad: And I broke one of the mounting bolts as I was putting it on which makes me question how good those bolts will hold??? That would suck to be driving down 64 and see the jack bouncing through the windshield of the car behind me...